NLService
2.Push the dosing aid forward. 4.Slide the detergent drawer into the
appliance.
14.9 Starting the program
Required:A program is set.
→
"Set program", page 32
1.on to press.
aThe drum rotates and a
load recognition takes place, which
can take up to 2 minutes, after
which the water flows into the
device.
aThe display shows the program
duration function ready in time. a
After the program end, it shows
display: End.
3.Fold the dosing aid downwards and
click into place.
2.If is selected, the laundry is not
spun and the water is drained
after rinsing.
Remark:If you do not remove the
laundry after the end of the
programme, the anti-crease program
starts after 15 minutes for approx. 30
minutes. The display shows 0:00and
displayed.
Press anywhere on the display to
cancel the anti-crease program and
take out the laundry.
4.Slide in the detergent drawer.
14.8 Dosing detergent and care
agent
Comments
sUse the dosing aid for liquid
Do not use with gel-like detergents,
washing powder, switched on
prewash or ready-in time. sKeep the
directions for washing
agent and laundry care agent
→
Page 32
at.
14.10 Soaking laundry
Remark:No additional detergent is
needed. The soapy water is then used
for washing.
1.Start the program.
1.Pull out the detergent drawer.
2.To pause the program, press after
approx. 10 minutes.
2.Fill with detergent.
Page 18
→
"detergent drawer",
3.To resume the program after the
desired soaking time, press
.
3.If desired with len. detergent filling
34
To Next Page
Loading...
