NLSet up and connect
PAY ATTENTION!
When draining, the water drain hose is
under pressure and can come loose
from the installed connection position.
▶ Secure the water drain hose against
unintentional disconnection.
4.6 Adjusting the device
To reduce noises and vibrations and to
prevent the device from walking, place
the device horizontally.
1.Loosen the lock nuts with a SW17
open-end wrench.
Remark:Observe the pumping
heights.
The pumping heights are: minimum
al: 100 cm
The connection position
tie with a
hose clamp
(24-40 mm) bore
gene.
washbasin the water drainage
feeding hose with
a bend
→
Page 31
fixate and
gene.
2.To adjust the appliance, turn the
appliance feet. Check the horizontal
adjustment of the appliance with a
spirit level.
plastic stand
pipe with rubber
run muff
the water drainage
feeding hose with
a bend
→
Page 31
fixate and
gene.
All appliance feet must be firmly
planted on the floor.
16
To Next Page
Loading...
