Bosch WIW...V0 series - Water Supply Filter Maintenance

en Cleaning and maintenance
48
Filter in the water supply
blocked
Relieve the water pressure in the
supply hose first:
1. Turn off the tap.
2. Select any programme (except
Rinse/Spin/Empty).
3. Start the programme.
4. Allow the programme to run for
approximately 40 seconds, then
switch off the appliance.
5. Pull out the mains plug.
Then clean the filter:
1. Disconnect the hose from the tap.
2. Clean the filter with a small brush.
3. For standard and AquaSecure
models, clean the filter on the rear of
the appliance:
Disconnect the hose from the rear of
the appliance.
4. For standard and AquaSecure
models, clean the filter on the rear of
the appliance:
a) Use pliers to remove the filter.
b) Clean the filter.
5. Connect the hose and check for
leaks.