enTroubleshooting
Disturbance Cause and troubleshooting
symbol voltage
exceeded (double
Point).
Undervoltage can cause a program extension.
No fix possible.
flashes. Undervoltage can cause a program extension.
No fix possible.
shines. temperature is too high.
▶ Wait for the temperature to drop.
▶
→
"Cancel program", page 32
Water level is too high.
▶ Choose a suitable pumping program.
→
"programs", page 24
flashes. door is not closed.
1.Close the door.
2.Press to start the programStart/ Reload .
Laundry is stuck in the door.
1.Open the door again.
2.Remove trapped laundry.
3.Close the door.
4.Press to start the programStart/ Reload .
All other error codes
of.
malfunction
▶ Call customer service.
→
"Customer Service", page 48
"E:30/-20" Solenoid valve defective.
▶ Call customer service.
→
"Customer Service", page 48
Detergent dosage is too high.
▶ For the next wash cycle with the same load, reduce
the amount of detergent.
Added additional water.
▶ Do not add additional water to the device during
operation.
device works
Not.
The mains plug of the mains connection cable is not plugged
in.
▶ Connect the device to the mains.
Fuse in the fuse box has blown.
▶ Check the fuse in the fuse box.
40
To Next Page
Loading...
