10
Operating Instructions
Bathroom Controller (YPRS67XBN) <Optional>
* Before use, remove the protective sheet from the remote controller surface.
What is actually displayed depends on how the water heater is set.
Setting Buttons
For setting the hot
water temperature
( p.14 -15)
For other settings.
Operation Button
For turning the water
heater on or off.
Bath Fill Button
To activate Bath Fill.
To set Bath Fill
temperature.
( p.18 -20)
Error Code
A number will flash if
a failure occurs.
( p.28)
Burner On Indicator
When this indicator is lit,
the hot water temperature
can be set. ( p.16)
Priority Indicator
When burning, the
indicator is lit.
( p.15, 19)
Bath Fill Temperature Indicator
When this indicator is lit,
bath fill temperature is
displayed. ( p.18 -20)
Temperature setting
(Eg.: 40°C)
Bath Fill Temperature setting
(Eg.: 40°C)
( p.18 -20)
Bath Fill Volume setting
Display
The illustration below shows the remote controller display.
What is actually displayed depends on how the water heater is set.
Display
Call Button
To sound alarm at all
remote controls. ( p.21)
Priority Button
To transfer control from
another remote
.
( p.16)
To Next Page
Loading...
