Bosch YS2180RAP - Sub Controller Operation

11
Operating Instructions
Sub Controller (YPRP62XBN) <Optional>
* Before use, remove the protective sheet from the remote controller surface.
What is actually displayed depends on how the water heater is set.
Error Code
A number will flash if
a failure occurs.
( p.28)
Burner On Indicator
When this indicator is lit,
the hot water temperature
can be set. ( p.16)
Priority Indicator
When burning, the
indicator is lit.
( p.15, 19)
Setting Buttons
For setting the hot
Water temperature.
( p.14 -15)
Temperature setting
(Eg.: 40°C)
Display
The illustration below shows the remote controller display.
What is actually displayed depends on how the water heater is set.
For turning the water
heater on or off.
Display
Operation Button