How to troubleshoot no power on Bose ControlSpace CC-64 Control Unit?
If your Bose Control Unit has no power, ensure the power supply is correctly wired and plugged in. Also, verify that the power supply is DC and provides at least 300mA at 15V. If you are supplying power over Ethernet, check that the jumpers behind the back panel are in the correct position.
What to do if the screen is blank on my Bose Control Unit?
If the screen on your Bose Control Unit is blank, press a button to see if the backlight comes on. The backlight turns off after a period of inactivity.
Why LEDs do not change when the knob is turned on my Bose ControlSpace CC-64 Control Unit?
If the LEDs on your Bose Control Unit do not change when the knob is turned, check the following: * Ensure that the device is connected to an ESP-88 directly with a crossover cable, or via a hub with a straight-through cable. * Verify that the Link LED is on, indicating a connection to another Ethernet device with the correct cable. * The CC-64 may not be programmed. Use the Designer software to map a signal-processing object to a Gain/Selector control. * The ESP-88 may not be powered or connected to the same Ethernet hub.
What to do if the Bose ControlSpace CC-64 does not respond when adjusting selector knobs?
If your Bose Control Unit isn't responding when you adjust the Selector or Gain/Selector control knobs, check that these parameters have been programmed using the Designer software. Also, verify that the control has been linked in the Designer software to signal processing blocks in the ESP-88. Make sure the CC-64 address matches the address of the device you programmed in Designer and that the new design was downloaded to the hardware from the Designer software.
Why is there no sound from my Bose ControlSpace CC-64 Control Unit even though it's powered on?
If your Bose Control Unit is powered on but producing no sound, check that the system is not muted. Also, check that other components, such as sources and amps, are not muted and are wired correctly.
How to find Bose Control Unit device in Creator?
If you cannot find the Bose Control Unit device in Creator, verify that an ESP-88 has been added to your design. Also, verify that the ESP-88 finds the CC-64. Look for the CC-64 in the Properties window and make sure it corresponds with the address you set on the CC-64.
A list of critical safety instructions for users and installers of the product.
Information on FCC compliance for digital devices and potential radio interference.
Cautions regarding installation, electrical codes, and regulatory information.
Overview of the Bose ControlSpace CC-64 as a programmable networked controller.
Highlights of the CC-64's main features like LCD, encoders, bank controls, and connectivity.
Detailed explanation of each button, knob, LED, and display on the CC-64 front panel.
Initial steps for installation: wiring, mounting box, connections, and software setup.
Guidance on installing the wall box and wiring the control center with Ethernet cables.
Details on power supply requirements, country-specific regulations, and connection methods.
Instructions for configuring power input via jumper settings for connector or Ethernet.
Pinout specifications for the RJ45 plug used for Ethernet connections.
Diagram and caution for wiring a power supply to the RJ45 plug for Power over Ethernet.
Guidance on resolving common issues like no power, blank screen, knob response, and connectivity.
Technical details including mounting cutout, power supply requirements, and unit dimensions.
Details on Bose's limited warranty, coverage, duration, and how to obtain service.
Information on owner's rights, transferability, liability limitations, and exclusions under the warranty.
Further warranty conditions, legal rights, remedies, and voiding conditions.
General| Type | Rotary volume control |
|---|---|
| Mounting type | Wall-mounted |
| Product color | White |
| Power handling | - W |
| Input operation voltage (max) | 24 V |
| Built-in display | Yes |
To Next Page
