9
SPECIFICATIONS
Signal Processing
Type: 32-bit floating-point digital signal processor(s)
Clock Speed: 200MHz
Maximum Calculation: 1600 MIPS/1200 MFLOPS
(6400 MIPS/4800 MFLOPS with DSP option card)
Delay Memory: 16MByte/72s (maximum)
(64MByte/288s maximum with DSP option card)
Audio Latency: 610us (analog in to analog out) (860us with DSP option card)
Sampling Rate: 48kHz
Control Inputs
Type: 8 analog or digital inputs, 5.1k ohms internal pull-up resistor
to 5V
Connectors: Phoenix/Euroblock 2-piece, 9-pin 3.81mm pitch
Analog Input: 0V to 3.3V (max 5V; suitable for 10k ohm variable resistor)
Digital Input Voltage Range: 0V to 3.3V (threshold voltage = 1.6V; internal 5.1k ohms pulled
up to 5V)
Control Outputs
Type: 8 digital outputs, 10k ohms internal pull-up resistors to 5V
Connectors: Phoenix/Euroblock 2-piece, 9-pin 3.81mm pitch
Output Voltage: 0V to 5V open collector
Output Current: 0.5mA (source)/10mA max (sink)
Communication Ports
LAN: 10Base-T (RJ-45)
RS-232C: D-sub 9 pin, male; DTE
RS-485: Phoenix/Euroblock 2-piece, 3-pin
Indicators
Status: Power/Status/Ethernet/Serial (RS232C + RS485)
Audio: Signal (Present/Normal/Clip) for each audio input and output
To Next Page
Loading...
Need help?
General
