71
DISASSEMBLY PROCEDURES
6.1 Remove the eight screws that secure
the SMPS / Amp assembly to the loud-
speaker enclosure. Take care to not strip the
screw heads.
6.2 Carefully lift the SMPS / Amp assembly
away from the enclosure. Take care to not
damage the gasket.
6.3 Disconnect the ground connection wire.
Retain the nut for re-use.
6.4 Disconnect the three wire harnesses at
J4, J5 and J7. Lift out the SMPS / Amp sub-
assembly.
Note: J5 is located opposite J4 on the other
side of the PCB assembly from the view
shown at right.
To Next Page
Loading...
