24 - Design Guide
CSD Properties and Operation
Beam Gain & EQ
Beam Gain: Gain for each beam.
Show Beam EQ: Indicates the Beam EQ. A Beam EQ is a filter that compensates the tonal balance of each
beam corresponding to the beam shape. The filter curve is automatically computed and updated every
time the beam pattern is sent from Modeler. You can change the curve shape manually and store to a
Beam Preset.
Freq: Center frequency.
Slope: Slope of the curve.
Gain: Hi-boost gain.
Restore Defaults: Return to the setting that was originally suggested from Modeler for that beam pattern.
Bypass: Bypass the beam EQ filter.
Status
Connected: Blue, when the connection between the array and CSD is active.
Standby: Red, when the array is in Standby. You can toggle the standby status by clicking the icon.
Health: Yellow, if there is a temperature warning. Red if there is a temperature fault or a driver fault. Green
otherwise.
Limit: Yellow, when output limiter is active for the array.
Level Meter: Level of input signal after the input Gain.
Hardware Configuration
Identify: When Dante® is enabled and the device is online, clicking this button triggers a flashing LED on
the back of the array.
IP Address: IP address of the MSA12X array. ‘Set…’ opens the Dante Properties window when Dante
connection is enabled.
Advanced…: Opens the Advanced Window.
To Next Page
Loading...
Need help?
General