56
➡ Recall the last measurement stored in the mem-
ory by pressing „M“ again after having recalled
the average value. The number of the measure-
ment appears in the display (see illustration 10).
The corresponding measurement value appears after
3 seconds (see illustration 11).
Displaying individual stored values
➡ Repeated pressing of „M“
will now successively dis-
play all measurements con-
tained in the memory as
described above.
➡ To start a new measure-
ment, simply press
„START“.
If no button is pressed, the unit
switches off automatically after
5 seconds.
Changing batteries
when the monitor is switch-
ed on can result in loss of
data (see page 43. Change
batteries only when the moni-
tor is switched off).
To Next Page
Loading...
