Boss AD-10 - Connecting a Footswitch or an Expression Pedal; Turning On;Off the Power

3
Getting Ready
Turning On/O the Power
Before you make connections, make sure that the input gain or volume of your mixer or amplier is turned down.
By turning on devices in the wrong order, you risk causing malfunction and/or damage to speakers and other devices.
* Before turning the unit on/o, always be sure to turn the volume down. Even with the volume turned down, you might hear
some sound when switching the unit on/o. However, this is normal and does not indicate a malfunction.
* When the batteries run low, the display indicates “
Bt
” When this occurs, install fresh batteries.
Connecting a Footswitch or an Expression Pedal
If you connect a footswitch (FS-5U, FS-6, FS-7: sold separately) or expression pedal (FV-500H, FV-500L, EV-30, Roland EV-5: sold separately)
to the CTL1,2/EXP jack, you'll be able to assign a variety of functions to it. “Assigning the Functions of the Pedals” (p. 12)
* Use only the specied expression pedal. By connecting any other expression pedals, you risk causing malfunction and/or
damage to the unit.
FS-7
FS-6 EV-30, EV-5FS-5U
FS-5U
1/4” phone type
10
1/4” phone type
Stereo 1/4” phone type
10
1/4” phone type x 2
Stereo 1/4” phone type
10
Stereo 1/4” phone