50
Recording
Recording Operations
1. Press [REC MODE] repeatedly until “INPUT” is
indicated for REC MODE at the left of the screen.
fig.01-109d
2. Press [REC].
[REC] flashes in red and the BR-900CD enters the
recording standby state.
fig.01-110
3. Press [PLAY].
The [REC] and REC TRACK buttons stop flashing in red
and instead light solidly, and recording starts.
fig.01-111
4. When you finish recording, press [STOP].
The REC TRACK button lights alternately in orange and
green, indicating that track contains recorded data.
* You cannot play back sounds recorded for less than one
second.
* During updating, “Keep power on!” appears in the upper line
of the display, while the lower line shows what is being
processed.
* The following operations cannot be used, or are disabled, while
the recorder is in use (during recording and playback).
• Recording patterns
• Editing arrangements
• Selecting drum kits
• Switching to the USB screen
• Switching to the Tone Load screen
• Switching to the Song Selection screen
• Switching to the Song New screen
• Switching to the Song Information screen
• Switching to the Edit Song screen
• Track Editing
• Switching to the Sync screen
• Switching to the Initialize screen
• Operating the CD-R/RW
Flash
Lit
To Next Page
