Boss DD-500 - Page 16

16
Parameter List
Parameter Value Explanation
WAV.FM
(WAVE FORM)
*1
SAW, TRI, SIN
Select one of the following to specify the change produced by the wave pedal.
SAW
TRI
SIN
TRIGGER
(INT PEDAL TRIGGER)
*2
Species how the motion of the internal pedal will be triggered.
PAT CNG
(PATCH CHANGE)
This is activated when a patch is selected.
EXP LO
This is activated when an external expression pedal connected to the CTL 1,2/
EXP jack is set to the minimum position.
EXP MID
This is activated when the external expression pedal connected to the CTL 1,2/
EXP jack is moved through the middle position.
EXP HI
This is activated when the external expression pedal connected to the CTL 1,2/
EXP jack is set to the maximum position.
CTL1, 2 PDL
This is activated when an external footswitch connected to the CTL 1,2/EXP
jack is operated.
CC#1–#31
CC#64–#95
This is activated when a control change is received.
TIME
(INT PEDAL TIME)
*2
0–100
This species the time over which the internal pedal will move from the toe-
raised position to the toe-down position.
CURVE
(INT PEDAL CURVE)
*2
LINEAR,
SLOW (SLOW RISE),
FAST (FAST RISE)
Select one of the following curves to specify the change produced by the
internal pedal.
LINEAR SLOW FAST
*1 SOURCE=INT PDL only
*2 SOURCE=WAVE PDL only