7. Installation requirements
The BOSS
TM
MX130/MX230 is a wall mounted unit and should be installed at a suitable eye
level, where the screen is easy to read and maintenance remains practical and possible. The
wall of the set-up location for the MX130/MX230 must be such that stability is guaranteed and
maintained. For general assembly instructions and commissioning steps of the product, see
MX130/ MX230 Quick Start Guide in link below:
https://www.bssboss.co.uk/pumps/pressurisation-units/
All BOSS
TM
products should be installed by a Qualified Person with regard to the relevant
requirements described in Appendix 2: Staff qualification. Check that the installation and other
actions prior to use have been carried out in full (e.g. power supply available and connected,
functioning or active fuses, seal tightness of the equipment). Any damage or loss incurred
through incorrect commissioning by an unapproved engineer will not be covered by the warranty.
The following conditions must be met before starting the commissioning process.
Failure to meet these conditions may result in injury or damage to the equipment,
system and/ or property.
To Next Page
Loading...
