9.2. Normal operation
In normal operation mode the system pressure is displayed.
Alarms or warnings will be displayed on the screen. You can find the description of these alarms
and warnings in chapter 10 troubleshooting.
For the settings menu please press and hold the button for 5 seconds. This will also be
displayed in the display with a countdown.
Move through the settings menu by clicking the button. Change settings by pressing the
or buttons. To save your settings go through all points and then save by pressing the
button. It says “saving”.
In the settings you can change:
• Safety valve
• Pressure set point
You can also check:
• Pump test
test/activate pump 1
test/activate pump 2
• Pump hours
Displays the operating hours of the pump(s)
• Alarm activation
Displays how often the alarm has been triggered
To Next Page
Loading...
