Basic Operation
16
3. Press the [RHYTHM] switch.
After the intro plays, the rhythm’s PTN 1 plays. At the
same time, the looper’s TRK 1 starts being recorded.
4. Press the [LOOP] switch.
The length of the TRK 1 is determined, and the
looper switches to the overdubbing state.
* The length of the track is automatically adjusted (loop
quantized) according to the tempo and the time
signature of the rhythm.
Start
Stop
Even if the timing is slightly inaccurate, the
phrase length will automatically be adjusted to
the precise measure interval.
5. Press the [LOOP] switch.
The looper switches to the loop playback state.
You can perform freely while playing back the
backing track that you created using the rhythm
and looper.
* The rhythm is not recorded on the looper.
* Even during loop recording, overdubbing, or playback,
you can freely insert a rhythm ll-in by pressing the
[RHYTHM] switch.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
