8
Temporary Override Mode
• During AUTO mode, the programmed temperature can be adjusted manually by pressing the
or buttons. The setting will flash for 5 seconds, then return to the home screen.
• This temperature override is cancelled at the next programmed temperature change.
• During Temporary Override mode, the program number is not displayed.
• Temporary Override mode remains active until the clock or program settings are adjusted,
COMF/ECON/OFF mode is activated, or the next program time is reached.
Program Setting Mode
You can change the program setting as follows:
1. Press Set to enter programming mode. Days will flash on the LCD for 10 seconds. Press or
repeatedly to step through the days, in consequent of 7 day, 5/2 day and 24 hour programme
options:
--- [M], [TU], [W], [TH], [F], [SA], [SU] -- [M, TU, W, TH, F], [SA, SU] -- [M, TU, W, TH, F, SA, SU] …
2. Press Select at any time to confirm the selection.
• Press Set to return to the home screen.
3. Program 1 will display with the Hours flashing. Press or to change.
• Press Select to set the hour.
• Press Set to return to the home screen and store the setting.
4. Program 1 will be displayed with the Minutes flashing, press or to change
• Press Select to set the minute
• Press Set to return to the home screen and store the setting.
5. Program 1 will display with the temperature flashing, press or to change
• Press Select to set the temperature.
• Press Set to return to the home screen and store the setting.
6. Program 1 and its temperature is set, Program 2 and the Hour will flash for 10 seconds to allow
you to set, repeat steps 3 to 5 (above).
7. After Program 6 is set, the next Day will flash as in step 1.
8. Repeat step 1 to 6 to set the rest days.
Note:
• During steps 1-8 (above), only or , Select and Set have functionality.
• During steps 1-8 (above), if there is no key press within 10 seconds, the unit will store the current setting and
return to AUTO mode.
Chronological sequence of programming
• If you set the start time of a programme to be later than a subsequent set programme, the
subsequent programme start time will be changed to the same.
• Similarly, if you set the time earlier than the previous program, the previous program start time
will be changed. The temperature setting will also be changed. See following examples:
Original
Program
1 Time: 06:30am Temp: 21°C
2 Time: 08:00am Temp: 18°C
3 Time: 10:00am Temp: 23°C
4 Time: 12:00pm Temp: 21°C
5 Time: 6:00pm Temp: 21°C
6 Time: 10:30pm Temp: 16°C
To Next Page
Loading...