Tool Model Fastener Type Fastener SKU Gauge Length
DA1520 15 1-1/4” (31mm)
DA1524 15 1-1/2” (38mm)
DA1532 15 2” (50mm)
DA1540 15 2-1/2” (63mm)
TOOL SPECIFICATIONS
All dimensions in inches unless otherwise specified.
-5-
Operating Pressure:
70 to 120 p.s.i.g. (4.9 to 8.43 kg/cm
2
). Select the operating pressure within in this range for best fastener
performance.
DO NOT EXCEED THIS RECOMMENDED OPERATING PRESSURE.
Air Consumption:
The DA1564K requires 4.2 cubic feet per minute or C.F.M. (118.9 liters per minute or LT/MIN) of free air at
80PSI (5.6 kg/cm
2
) to operate at a rate of 100 fasteners per minute. To determine the appropriately sized air
compressor, take the actual rate at which the tool will be run and compare the required C.F.M. (LT/MIN) to the
compressors free air delivery (C.F.M./ LT/MIN) at 80 PSI (5.6 kg/cm
2
).
For example, if your fastener usage averages 30 fasteners per minute, you need 30% of the tools C.F.M.
required to operate the tool at the rate of 100 fasteners per minute. In this case, be sure that your air
compressor can deliver a minimum of 1.26 C.F.M. (35.6 LT/MIN) at 80 PSI (5.6 kg/cm
2
) for optimum
performance.
FASTENER SPECIFICATIONS
*Visit www.BOSTITCH.com for further details.
NOTE:
BOSTITCH tools have been engineered to provide superior customer satisfaction and are designed to achieve
maximum perfomance when used with precision BOSTITICH fasteners engineered to the same exacting
standards. BOSTITCH cannot assume responsibility for product performance if our tools are used with
fasteners or accessories not meeting the specific requirements established for genuine BOSTITCH
fasteners and accessories.
DA1564K
D
escription DA15ga Angled Finish Nailer
Engine Type Oil-Free
Operation Pressure Range 70-120 PSI (4.9 to 8.43kg/cm
2
)
Maximum Operation Pressure 120 PSI (8.43 kg/cm
2
)
F
astener Type DA15 Series
F
astener Gauge 15 Gauge
Fastener Range 1-1/4” – 2-1/2” (31mm – 63mm)
M
agazine Capacity 100
Length 12-9/16” (319.5mm)
Width 3-5/8” (92mm)
Height 11-13/16” (300mm)
Weight 4.15 lbs. (1.8kg, Including fitting)
DA1564K
DA Type Angled Finish Nails
To Next Page
Loading...
