Need help?Do you have a question about the Bostitch PN50 and is the answer not in the manual?
Requires ANSI-compliant eye protection from front and side to prevent severe eye injury from flying particles.
May require hearing and head protection depending on the work environment to prevent injury.
Warns against using oxygen or combustible gases as a power source due to explosion risk.
Warns against exceeding 200 P.S.I.G. supply sources to prevent tool bursting.
Ensures the tool connector does not hold pressure after disconnection to prevent accidental firing.
Lists situations where air supply must be disconnected to prevent accidental actuation and injury.
Emphasizes careful handling, no horseplay, and keeping others at a safe distance during operation.
Warns against driving fasteners on top of others or at steep angles, and near edges to prevent deflection and splitting.
Prohibits use near flammable substances or vapors due to explosion risk causing injury or death.
Instructs to place nails into the tool only after the air source is fully connected.
Recommends using BOSTITCH parts and ensuring internal parts are clean and lubricated.
Advises frequent, non-excessive lubrication with specific air tool lubricants for optimal performance.
Discusses preventing moisture freezing and recommends specific lubricants for cold conditions.
To Next Page
General
