To Next PageTo Next Page
Need help?Do you have a question about the Bostitch N80CB and is the answer not in the manual?
General| Type | Coil Framing Nailer |
|---|---|
| Nail Length | 1-1/2" to 3-1/4" |
| Operating Pressure | 70-120 psi |
| Power Source | Pneumatic |
| Fastener Type | Wire weld collated |
| Magazine Angle | 15 Degree |
Details nail sizes and diameters for N80CB and N80CB-HQ models.
Specifies the required air fitting size and type for the tool.
Specifies the recommended operating pressure range for optimal performance.
Details the air consumption rate for the tool based on usage.
Explains the contact trip operation method for driving fasteners.
Explains the sequential trip operation method for driving fasteners.
Refers to operation instructions for identifying the tool's operating system.
Details requirements for the tool's male air fitting for proper air release.
Specifies minimum working pressure rating and quick disconnect requirements for air hoses.
Emphasizes using only clean, regulated compressed air, not oxygen or combustible gases.
Requires a pressure regulator to control operating pressure within safe limits.
Advises against exceeding recommended maximum operating pressure to avoid increased wear.
Explains the importance of filters for tool performance and wear prevention.
Instructions for opening the tool's magazine cover and door.
Guidance on adjusting the canister for correct nail length feeding.
Steps for properly loading a coil of nails into the tool's magazine.
Instructions for closing the tool's magazine cover.
Steps for closing the tool's magazine door and ensuring latch engagement.
Essential preliminary steps including reading warnings and identifying the operating system.
Details two methods (single fastener, rapid fastener) for operating contact trip models.
Explains the procedure for operating sequential trip models to drive fasteners.
Specific tests to verify correct operation of contact trip models.
Specific tests to verify correct operation of sequential trip models.
Important safety rules to observe during tool operation.
Recommendation to use genuine BOSTITCH replacement parts.
Guidance on lubricating and assembling internal seals during repair.
Explains the importance of adequate air volume and pressure for tool function.
Identifies causes and corrections for air leaks from the trigger valve housing.
Identifies causes and corrections for air leaks from the frame or nose.
Troubleshooting steps for when the tool fails to cycle.
Troubleshooting steps for reduced power or slow cycling.
Troubleshooting steps for skipped fasteners or intermittent feeding.
Troubleshooting steps for when fasteners jam in the tool.
Troubleshooting steps for skipped fasteners specific to coil nailers.
Troubleshooting steps for fastener jams specific to coil nailers.
Describes issues caused by a worn driver and the need for adjustment.
Instructions on adjusting the directional exhaust deflector.
