To Next PageTo Next Page
Need help?Do you have a question about the Bostitch N60FN and is the answer not in the manual?
General| Type | Finish Nailer |
|---|---|
| Power Source | Pneumatic |
| Magazine Capacity | 20-22 nails |
| Operating Pressure | 70-120 PSI |
| Weight | 4.5 lbs |
| Tool-Free Depth Adjustment | Yes |
| Tool-Free Jam Release | Yes |
| No-Mar Tip | Yes |
| Fastener Size/Length | 1-1/4 - 2-1/2 in |
| Fastener Length | 1-1/4" to 2-1/2" |
Overview of the Bostitch N50FN/N59FN/N60FN series nailers and the importance of following the manual.
Details the warranty period, coverage, exclusions, and claims process for Bostitch tools.
Mandates the use of ANSI-compliant eye protection to prevent severe eye injury from flying particles.
Highlights the need for hearing and head protection in environments with specific risks.
Warns against using improper air sources and stresses disconnecting air supply before adjustments.
Provides crucial warnings to prevent accidental injuries while loading nails into the tool.
Outlines safe handling practices, trigger usage, and keeping body parts away from the discharge area.
Advises caution and adherence to manual warnings when working on air tools.
Details tool air fitting requirements, recommended operating pressure, and air consumption rates.
Describes the contact trip firing mode, including single placement and rapid fire methods.
Explains the sequential trip mode requiring contact before trigger actuation for precise firing.
Details the operation mode where the trigger alone drives a fastener each time it is pulled.
Specifies requirements for air supply components like fittings, hoses, and clean compressed air.
Details the necessity of a regulator and maintaining pressure within specified limits for safe use.
Explains the role of air filters in ensuring performance and minimizing wear on pneumatic tools.
Covers proper lubrication techniques and recommendations for cold weather operation.
Emphasizes eye protection and general safety rules to prevent accidental injuries during loading.
Step-by-step guide for loading nails, engaging the pusher, and changing nail lengths.
Guides users to read warnings and identify the tool's operating system before initial use.
Explains the basic function of a trigger-only operated tool for driving fasteners.
Details the two methods for operating a contact trip tool: single placement and rapid fire.
Describes how to operate a sequential trip tool by depressing contact trip then trigger.
Procedure to verify the correct function of a trigger-only operated tool before use.
Steps to confirm the proper operation of the contact trip mechanism without actuation.
Instructions to verify the correct functionality of the sequential trip system.
Warns about potential pinch hazards and thin edges of the pusher spring assembly during maintenance.
Recommends using genuine BOSTITCH replacement parts for optimal performance and longevity.
Guides on cleaning and lubricating internal parts, especially O-rings, during repair and reassembly.
Explains how inadequate air volume or flow restriction can negatively impact tool performance.
Steps to adjust fastener drive depth by turning the adjusting nut on the trip cover.
Procedures for opening the quick release door to safely remove jammed fasteners.
