Bostitch N12B Series User Manual

AIR SUPPLY AND CONNECTIONS
AWARNING:
Do not use oxygen, combustible gases, or bottled gases as a power source for this tool as tool may
explode, possibly causing injury.
FITTINGS:
Install a male plug on the tool which is free flowing and which will release air pressure from the tool when disconnected
from the supply source.
HOSES:
Air hoses should have a minimum of 150 p.s.i. (10.5 kg/cm 2 ) working pressure rating or 150 percent of the maximum
pressure that could be produced in the air system, which ever is higher. The supply hose should contain a fitting that
will provide “quick disconnecting" from the male plug on the tool.
SUPPLY SOURCE:
Use only clean regulated compressed air as a power source for this tool. NEVER USE OXYGEN, COMBUSTIBLE GASES,
OR BOTTLED GASES, AS A POWER SOURCE FOR THIS TOOL AS TOOL MAY EXPLODE.
REGULATOR:
A pressure regulator with an operating pressure of 0 -125 p.s.i. is required to control the operating pressure for safe
operation of this tool. Do not connect this tool to air pressure which can potentially exceed 200 p.s.i. as tool may
fracture or burst, possibly causing injury.
OPERATING PRESSURE:
Do not exceed recommended maximum operating pressure as tool wear will be greatly increased. The air supply must
be capable of maintaining the operating pressure at the tool. Pressure drops in the air supply can reduce the tool’s
driving power. Refer to “TOOL SPECIFICATIONS” for setting the correct operating pressure for the tool.
FILTER:
Dirt and water in the air supply are major causes of wear in pneumatic tools. A filter will help to get the best
performance and minimum wear from the tool. The filter must have adequate flow capacity for the specific installation.
The filter has to be kept clean to be effective in providing clean compressed air to the tool. Consult the manufacturers
instructions on proper maintenance of your filter. A dirty and clogged filter will cause a pressure drop which will reduce
the tool’s performance.
LUBRICATION
Frequent, but not excessive, lubrication is required for best performance. Oil added thru the air line connection will lubricate
the internal parts. Use STANLEY-BOSTITCH Air Tool Lubricant, Mobil Velocite #10, or equivalent. Do not use detergent
oil or additives as these lubricants will cause excellerated wear to the seals and bumpers in the tool, resulting in poor
tool performance and frequent tool maintenance.
If no airline lubricator is used, add oil during use into the air fitting on the tool once or twice a day. Only a few drops
of oil at a time is necessary. Too much oil will only collect inside the tool and will be noticeable in the exhaust cycle.
COLD WEATHER OPERATION:
For cold weather operation, near and below freezing, the moisture in the air line may freeze and prevent tool operation.
We recommend the use of STANLEY-BOSTITCH WINTER FORMULA air tool lubricant or permanent antifreeze (ethylene
glycol) as a cold weather lubricant.
CAUTION: To prevent frost or ice formation on the tool’s operating valves and mechanisms that could cause tool failure,
do not store tools in a cold weather environment.
NOTE: Some commercial air line drying liquids are harmful to “0”-rings and seals — do not use these low temperature
air dryers without checking compatability.
- 5 -

Bostitch N12B Series Specifications

General

Brand	Bostitch
Model	N12B Series
Category	Nail Gun
Language	English