02 03
2. Technical After Services
BougeRV provides 1-on-1 Solar Solution.
If you have any questions during use, please feel free to contact us:
If you could provide the following relevant information to our email
(service@bougerv.com); we can provide you with technical support solutions
faster.
(1)The connection method of the solar panels (series/parallel, quantity, voltage,
power).
(2)The voltage and battery type of the battery.
(3)The pictures or videos of the controller: battery voltage, battery
charging current, the output voltage of the solar panel.
service@bougerv.com
1-408-656-8402
www.bougerv.com
1-669-232-7427
Whataspp
1. Safety Instructions
Please follow the safety instructions for operation, the damage caused by not following
the safety instructions shall be borne by the individual.
Please save these instructions
1.Read all of the instructions and cautions in the manual before installation.
2.There are no repairable parts for this controller,do not disassemble or attempt to repair
the controller.
3.Keep the controller from the water.
4.Make sure all connections with controller are tight.
5.Please read the product installation steps to ensure all connections are correct.
1-1.General Safety Information
1-2.Charge Controller Safety
1-3.Battery Safety
1.NEVER connect the solar panel array to the controller without a battery. The battery
must be connected first.
2.Ensure input voltage does not exceed 150 Voc to prevent permanent damage.
3.Ensure that the output current of the solar panel does not exceed the rated charging
current of the controller.
1 . Do not let the positive (+) and negative (-) terminals of the battery touch each other.
2. Explosive battery gases may be present while charging. Be certain there is enough
ventilation to release the gases.
3. Be careful when working with large lead-acid batteries. Wear goggles and have fresh
water available in case there is contact with the battery acid.
4. Over-charging and excessive gas precipitation may damage the battery plates and
activate material shedding on them. Too high of an equalizing charge or too long of
one may cause damage. Please carefully review the specific requirements of the battery
used in the system.