6
IMPORTANT: Always use ALKALINE batteries only.
Do not use heavy duty batteries.
DON’T MIX OLD AND NEW BATTERIES
Always remove the batteries for prolonged storage.
CHECK THE BATTERIES if your detector exhibits any of the following
symptoms:
●
1 The unit does not turn on.
●
2 Low speaker volume.
●
3
Unit beeps continuously or erratically.
The LOW BATTERY indicator will come on and stay on if the batteries
are discharge. You may notice erratic beeping if using with LOW
BATTERY illuminated.
IMPORTANT: Your Quick Silver metal detector requires two 9-Volt
ALKALINE batteries.
Follow these steps to install the batteries.
●
1 Carefully remove the battery compartment door by pressing the release
clip on the right side of the door.
●
2 Snap one
battery onto
each of the
terminals and
place the bat-
teries inside the
compartment.
Insert booth of
the batteries
with terminals
facing inward.
●
3
Replace the
compartment
door by carefully
inserting oppo-
site side of clip
first. Then press
BATTERIES
Release
Clip
Both Batteries
teminals
facing in
To Next Page
Loading...
