To Next PageTo Next PageWhat to do if my Bounty Hunter Time Ranger Metal Detector is repeating a loud tone?
If your Bounty Hunter Metal Detector is repeating a loud tone, the batteries may be low, so replace them as described in the manual. The coil or coil connection could also be damaged, in which case you should replace the coil. You may also try to reset the detector and check the coil plug connection.
Why is my Bounty Hunter Metal Detector not stable?
If your Bounty Hunter Metal Detector is not stable and has a pulsing, distorted tone, you might be operating too close to another detector. Move at least 20 feet away from any other detectors. Alternatively, you might be operating near power lines that are interfering with the detector’s frequency, so try moving away from power lines.
Why is my Bounty Hunter Metal Detector emitting false signals?
Your Bounty Hunter Metal Detector might be emitting false signals because the SENSITIVITY is set too high. Try reducing the SENSITIVITY as described in the manual for your mode of operation. Also, make sure you swing the coil slowly. The issue may also be caused by highly oxidized metal. If the signal doesn't repeat when sweeping the same area, the target is likely highly oxidized (rusted) metal and not worthwhile.
General| Search Modes | All Metal, Discrimination |
|---|---|
| Discrimination | Yes |
| Pinpoint Mode | Yes |
| Frequency | 6.6 kHz |
| Display | LCD |
| Target ID | Yes |
| Depth Indicator | Yes |
| Sensitivity Adjustment | Yes |
| Volume Adjustment | Yes |
| Battery Type | 9V |
| Ground Balance | Manual |
| Type | VLF |
| Intended Use | Coin, Relic, and Jewelry Hunting |
| Headphone Jack | Yes (1/4 inch) |
| Search Coil | 8 inch |
| Battery Life | 25 hours |
| Audio Tones | 3-Tone |
