BÖWE P 240 - Page 39

36
9. Technical data
P 300 with /without Slimsorba
Heating steam electr.
CONSUMPTION DATA:
CONSUMPTION PER LOAD*
El. energy total without /with Slimsorba kWh 2.4 /2.6 8.8/10.6
El. energy drying without /with Slimsorba kWh 2.2 /2.3 3.5 /3.6
El. energy still kWh - 5.3
Saturated steam drying without /with Slimsorba kg 2.8/3.0 -
Saturated steam still kg 6.5 -
Cooling water drying without /with Slimsorba l 55 /70 60 /70
Cooling water still l 85 95
Compressed air (6 bar) l 6 6
OTHER DATA:
Still throughput (DIN 11916) max. l/h 120 75
Filter throughput l/h 4000 4000
Filter surface ECO-filter m
2
2.4 2.4
Weight without solvent Slimline /Crossline kg 1080 /1100 1080 /1100
Weight with solvent Slimline /Crossline kg 1470 /1490 1470 /1490
Carbon-filling Slimsorba kg 10 10
Floor surface Slimline /Crossline m
2
2.3/2.5 2.3/2.5
Used floor surface*** Slimline /Crossline m
2
1.41/1.41 1.41 /1.41
Centrifugal cage force N 6000 6000
Floor load (stat. and dyn.) max.
. Slimline /Crossline N/m
2
14500 /14600 14500 /14600
Noise level dB(A) 64 64
HEAT BALANCE:
Heat eliminated by cooling water****:
with /without Slimsorba kJ/h 32000 /31000 33500 /32500
Heat radiation to the ambient*:
with /without Slimsorba kJ/h 11700 /11500 11700 /11500
* Values apply to a standard 2-bath-cycle, 1. bath to distillation at cooling water inlet temperature + 12 °C (53.6 °F).
Drum outlet temperature 50 °C (122 °F), condensation pressure 22 bar (319 psi), drying 18 minutes, reduction 6 minutes,
steam supply 4 - 5 bar (58 - 72.5 psi) saturated steam, ambient temperature + 1 to + 40 °C (+ 34 to 104 °F),
with Slimsorba 3 min. reduction, 6 min. adsorption.
*** used part of floor surface for force transmission see point 6.3.1
**** refers to water without any additive
Subject to technical changes!