21
P21/P26/P30
6. Operation 6.
6.1.4 Filling Slimsorba Carbon Container (Optional Equipment)
For the first startup, perform the following steps in the order given to fill the carbon container with
activated carbon:
1. Loosen the upper tube of the carbon container
2. Loosen the quick release fastener on the cover and lift off the cover
3. Remove fine filter sieve and clamping ring.
4. Fill in 15 Kg of activated carbon (cylindrical pellets with approx. 4 mm/0.16 inch diameter, type
SUPERSORBON K40). The heating coil must be covered.
5. Replace the fine filter sieve and clamping ring.
6. Replace the cover and close the quick release fasteners.
7. Secure the upper tube of the carbon container again.
The Slimsorba is an integrated multiple-cycle unit for reducing the solvent residue in perc machines.
The Slimsorba is desorbed with hot air.
To Next Page
Loading...