88
Cap
Cap
Rear Shroud
Cap
Leg Assembly
Note: Replace any damaged hardware with the new hardware provided
with this kit for re-assembly.
TheBowexMaxTrainer
®
M3 is used in the following images.
1. Unplug the AC Adapter from the wall outlet and machine.
2. Using a 5mm hex wrench, remove the indicated hardware from the
Upper Handlebars.
Note: Be aware that the Upper Handlebars must be supported when
removing the hardware.
3. Remove the indicated Cap from both sides of the machine.
4. Using a 6mm hex wrench, remove the hardware exposed from below
the Cap from both sides of the machine.
5. Slide the Leg Assemblies off of the machine.
6. Using a #2 Phillips screwdriver, remove the indicated screw from the
Rear Shroud.
7. Carefully remove the Rear Shroud from the machine. Place a standard
screwdriver behind and near the middle of the Rear Shroud and gently pry
until it releases. Then move the screwdriver to the bottom and gently pry
until the Rear Shroud comes off.
8. Remove the indicated Caps from the machine.
To Next Page
Loading...
