81
33. Final Inspection
Inspect your machine to ensure that all hardware is tight and components are properly assembled.
Do not use until the machine has been fully assembled and inspected for correct performance in
accordance with the Owner’s Manual.
30. The console display will change to “CNFRM C4095
AGC xx”.
31. Push the Enter/Start button to confirm and save
the resistance calibration values. The display will
momentarily change to “SAVING CAL”, then display
“AUTO CAL_RESISTANCE”. Calibration is complete.
Note: Pushing the Pause/Stop button will abort the
calibration process, with the new calibration values not
being saved, and the last saved calibration values being
restored.
32. Power o the machine.
To Next Page
Loading...
