X67 system
4.3.3 Accessories
All accessories needed for installation are available from B&R:
Pre-assembled cables
The following pre-assembled cables are available in various lengths and designs:
•
POWERLINK cables
•
CAN bus / DeviceNet cables
•
PROFIBUS DP cables
•
X2X Link cables
•
Module power supply cables
•
M8 sensor cables
•
M12 sensor cables
•
Multi-function module cables
•
Valve terminal cables
Field-assembled connectors
The following connectors are available for field assembly:
•
CAN bus / DeviceNet
•
PROFIBUS DP / X2X Link
•
POWERLINK
•
I/O power supply
•
Sensors/Actuators
•
Special-purpose connectors
Other accessories
•
Terminating resistor
•
Connectors
•
Threaded caps
•
Mounting plates for top-hat rails
•
Installation tool
Notice!
For the dependable installation of pre-assembled X67 cables, B&R recommends using the torque
wrench available as an accessory!
All further information is available in the X67 system user's manual.
Order number Short description Figure
Mounting tools
X67ACTQMX X67 torque wrench set, for X67 M8 and M12 connectors, for hex-
head connectors
Table 9: X67ACTQMX - Order data
Installation / EMC guide 1.36 (April 2021) 27
To Next Page
Loading...