To Next PageTo Next PageWhy is the top of the marker cut through when cutting PSPT markers on my Brady TLS2200?
If the top of the marker is cut through when cutting PSPT markers on your Brady Printer, it's likely that the movable material guide isn't fully locked in place. Verify that it's fully locked into the proper notch in the guide plate.
What to do if my Brady TLS2200 Printer displays 'Error Head Too Hot'?
If your Brady Printer shows 'Error Head Too Hot', the print head can't reliably print due to heat buildup. Press the or button to clear the display, and then allow the printer to cool for ten minutes before printing again.
How to clear 'Error Head Open' on Brady TLS2200?
If your Brady Printer displays the 'Error Head Open' message, it means the print head is unlocked. Move the lever on the right side of the TLS2200™ printer to the lock position. Then, press the or button to clear the display.
What does 'Error Out of Label' mean on my Brady Printer and how do I fix it?
The 'Error Out of Label' message on your Brady Printer means the roll of markers is either not feeding properly or has run out. Press the or button to clear the display. If the roll is empty, install a new one. If the markers aren't feeding correctly, ensure the leading edge is inserted into the material path until it hits the feed roller and that the edge is straight. If skewed or jammed, press the key to recalibrate, or open the print head and pull the markers through to clear the jam.
How to fix Brady Label Maker cutting through top of marker?
If the top of the marker is cut through when cutting PSPT markers on your Brady Label Maker, verify the movable material guide is fully locked into the proper notch in the guide plate.
What does 'Memory Full' mean on my Brady Label Maker and how to fix it?
The 'Memory Full' message on your Brady Label Maker indicates that either there are ten lists (the maximum) already saved in memory, or the memory has reached capacity while trying to save a legend to a list. To resolve this, delete one or more lists or legends.
What to do if my Brady Label Maker shows 'Error Out of Label'?
If your Brady Label Maker displays 'Error Out of Label', first press the or button to clear the display. If the roll has run out, install a new marker roll. If you have not run out of markers, ensure the leading edge of the markers is inserted into the material path until they hit the feed roller and that the leading edge is straight, cutting it with scissors if necessary. If the markers are present and printing, they may have become skewed or jammed; press the key to recalibrate, or open the print head and pull the markers through to clear the jam.
What does 'Wrong Part! Use PTL-XX-XXX' mean on my Brady TLS2200?
The 'Wrong Part! Use PTL-XX-XXX' message on your Brady Printer indicates that the loaded part is not the correct one for the selected list or the legend you're trying to save. Load the correct part that the list was created for.
Why does my Brady TLS2200 Printer say 'Reduce Type Size'?
The 'Reduce Type Size' message on your Brady Printer indicates the line is full or you've exceeded the marker height. If it appears while typing, press + to reduce the font size. If it appears when you press , reduce the font size or bar code height and try printing again.
What to do if my Brady TLS2200 Printer will not feed labels?
If your Brady Printer isn't feeding labels, it could be due to several reasons: * The marker roll was fed through the material guide slots before closing the print head: Unlock the ribbon cartridge-locking lever to open the print head, remove the marker material, close the print head by locking the lever, and then feed the markers through the guide slots. * The marker roll's leading edge isn't fully inserted: Feed the leading edge until you meet resistance. * The leading edge is uneven or torn: Use scissors to cut a straight edge.
General
