Need help?Do you have a question about the Brady BP-PR 300 PLUS Series and is the answer not in the manual?
General| Print Technology | Thermal Transfer |
|---|---|
| Print Resolution | 300 dpi |
| Cutter | Optional |
| Max. Print Width | 4.27 inches |
| Print Speed | 100 mm/s |
| Connectivity | USB, Ethernet, Serial |
| Maximum Print Width | 4.27 inches |
| Supported Label Materials | Polyester, Polypropylene, Vinyl, Paper |
| Label Width Range | 0.5 to 4.33 inches (13 to 110 mm) |
| Label Thickness Range | 0.002 to 0.008 inches (0.05 to 0.2 mm) |
General overview of the BP-PR PLUS Series transfer printers, their operation modes, connectivity, and features.
Steps for connecting the printer using an RS-232 cable and configuring settings.
Instructions for connecting the printer to a network via Ethernet.
Procedure for connecting the printer via a USB interface and installing the driver.
Setting printer parameters using the operating panel during initial setup and changes.
Setting printer parameters remotely via the printer's web interface.
Instructions for updating the printer's firmware via interface or memory card.
Saves the current printer configuration to a CompactFlash memory card.
Loads a previously saved printer configuration from a CF card.
Procedure for updating printer firmware using FTP.
To Next Page
