Braeburn 1020 - Operating Your Thermostat; Setting the System Control Mode; Setting the Fan Control Mode

7
User Factory Setting
No. Options Default Options Comments
  TUTUBHF 0.5 0.5, 1.0 4FMFDUBTUTUBHFUFNQFSBUVSF
   EJGGFSFOUJBM  
or 2.0 EJGGFSFOUJBMPGPS'
       PS$
  OETUBHF
2.0 1.0, 2.0,  4FMFDUBOETUBHFUFNQFSBUVSF
   EJGGFSFOUJBM  
3.0, 4.0  EJGGFSFOUJBMPGPS'
 0OMZ 5.0 or 6.0  PS$
Table of User Options
Detailed Explanation of User Options:
Temperature Differential
(User Option 1 and 2)
5IFEJGGFSFOUJBMTFUUJOHJTUIFUFNQFSBUVSFDPOUSPMSBOHFUIBUZPVSUIFSNPTUBU
XJMMQSPWJEF5IFTNBMMFSUIFTFUUJOHUIFUJHIUFSZPVSSBOHFPGUFNQFSBUVSF
DPOUSPMBOEDPNGPSUXJMMCF5IFOETUBHFEJGGFSFOUJBMJTPOMZGPSTZTUFNT
XJUIBTFDPOETUBHFPGIFBUJOHBVYJMJBSZIFBU
6
Operating Your Thermostat
Setting the System Control Mode
5IF4ZTUFN$POUSPMIBTTFWFSBMNPEFTPGPQFSBUJPOUIBUDBOCFTFMFDUFECZ
NPWJOHUIF4:45&.TXJUDIUPUIFBQQSPQSJBUFQPTJUJPO
COOL 0OMZZPVSDPPMJOHTZTUFNXJMMPQFSBUF
OFF )FBUJOHBOEDPPMJOHTZTUFNTBSFPGG
HEAT 0OMZZPVSIFBUJOHTZTUFNXJMMPQFSBUF
Additional Switch Position (Model 1220 Only):
EMER 0QFSBUFTBCBDLVQIFBUTPVSDF&NFSHFODZ)FBUGPSIFBUQVNQ
 TZTUFNTPOMZ
NOTE: If your model 1220 was configured for a
conventional system (CONV) then you will not have
the EMER (emergency heat) option and “NO EMER
SET” will flash in the display if EMER is selected
with the system switch.
Setting the Fan Control Mode
The Fan Control has 2 modes of operation – AUTO
and ON. The mode can be selected by moving the
FAN switch to the appropriate position.
AUTO 5IFTZTUFNGBOXJMMSVOPOMZXIFOZPVS
  IFBUJOHPSDPPMJOHTZTUFNJTSVOOJOH
ON 5IFTZTUFNGBOTUBZTPO