CAP. 13 - MAINTENANCE 58 / 73 ENGLISH
î
P
OSSIBLE ERROR INDICATION:
Tank empty or valves closed alarm
13.7 NON-CONDENSABLE GAS DISCHARGE
By selecting this function, you can check the non condensable gases condition (high level red
area, low level green area ) and if necessary you can start manually the discharge.
13.8 MULTIPASS
By selecting this function, you can start the multipass function, allowing for a further recycle,
which is internal to the station itself. This mode guarantees a higher level of the service quality.
13.9 SYSTEM INFORMATION
By selecting this function, you can display the identifying codes and the electronic boards software
version of the 9000 BUS PLUS station.
13.10 MAINTENANCE OF PRINTER
To change the roll of paper follow instructions below:
Open the lid of the printer as shown.
Position the roll of paper inside the housing in the rotation direction indicated in the picture;
Pull the paper (or the feed button) until you can extract it from the plate as indicated in the picture
and then close the door;
The printer is ready for printing.
To Next Page
Loading...