ENGLISH 39 / 73 CAP. 9 - SETUP
CAP. 9 - SETUP
The SETUP menu enables you to set various parameters and switches:
HYBRID FUNCTION
• by selecting this entry, one may change the type of Oil to inject into the A/C system.
Attention: the HYBRID KIT PRO (optional accessory) is required in order to run this function
ECO LOCK®
• by selecting this entry, you can enable the ECO LOCK® function (the ECO LOCK® quick
coupler must be present on the car).
RECHARGE MODE
• by selecting this entry, one may decide whether to enable use of the Quick Mode or Zero
Tolerance recharge method
PRESSURE CHECK
• by selecting this entry, one can enable or disable the pressure check.
AIR PURGE SYSTEM
• by selecting this entry, one can enable or disable the AIR PURGE SYSTEM function. If
enabled, on a weekly basis, the station, when switched on, will suggest the user to run the
procedure . If disabled, execution of the procedure will no longer be suggested.
MULTIPASS
• by selecting this entry, one may decide whether or not to enable the multipass function,
which enables an additional recycling, within the station itself, started in automatic when it
is switched on but not in use. This function ensures a higher level of purity of the recycled
refrigerant to the advantage of the service quality.
RECOVERED GAS AND OIL PRINTING
• selecting this entry, you can choose whether you want to enable displaying and printing of
the recovered gas quantity.
REPORTS SAVING MODE
• by selecting this entry, you can decide whether to save the A/C services performed on the
tool, choosing between automatic cycles only or automatic and manuals cycles ( through
data transmission to CLIMA-SOLUTION).
REPORT DATA
• select what data you would like to include in the saved and printed report:
-license plate
-km
-client’s name
-technician’s name
HOSES LENGTH
• by selecting this entry, it will be possible to change the length of the charge hoses
To Next Page
Loading...