Branson 00 Series User Manual

155 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

Branson 00 series

Operator’s manual

00 OPERATORS MANUAL (040512).indd 1 4/12/2012 10:19:37 AM

Table of Contents

Questions and Answers:

B
Brandon MahoneyAug 21, 2025
What to do if my Branson 00 Series motor does not start when turned to START?
- S
  smarquezAug 21, 2025
  If the motor of your Branson Tractor fails to start when the main switch is turned to START, consider the following: * Ensure the battery solution is sufficient and the battery is fully charged. * Check for loose or corroded battery terminals; clean and tighten them, applying grease to prevent rust. * Inspect the main fuse and replace it if burnt out. * If these steps do not resolve the issue, the key switch or starting motor may be faulty, and you should contact the dealer for repair or replacement.
L
Louis MasseyAug 22, 2025
What to do if my Branson 00 Series Tractor engine is overheated?
- M
  Melissa MurphyAug 23, 2025
  If your Branson Tractor engine is overheating, check the following: * Ensure the coolant level is adequate and refill if low. * Inspect the fan belt for slack or damage; adjust or replace as needed. * Clean any clogs from the radiator fin. * Check the engine oil level and refill if low. * Reduce the load on the engine if it's running under too much stress.
J
Joyce MyersAug 25, 2025
Why is the engine power of my Branson Tractor too weak?
- R
  Randall ThomasAug 25, 2025
  If your Branson Tractor's engine power is too weak, start by inspecting the air cleaner for clogs. If the problem persists, the nozzle may be stained with carbon, in which case you should contact the dealer for repair. Also, the compression force may be weak, the valve clearance might not be properly adjusted or the injection timing could be bad.
D
Dr. Tamara StewartAug 26, 2025
What to do if engine oil warning lamp is on during operation of Branson 00 Series Tractor?
- O
  owilliamsAug 26, 2025
  If the engine oil warning lamp illuminates during operation of your Branson Tractor, take these steps: * First, check the engine oil level and refill if it's low. * If the oil level is adequate, the engine oil viscosity might be too low; replace the engine oil with one of proper viscosity. * If the issue continues, the pressure switch may be faulty and require replacement. In some cases, the oil pump may be out of order, requiring you to contact the dealer for repair.
H
Heather NicholsonAug 27, 2025
What to do if my Branson Tractor motor starts, but the engine does not?
- M
  myerslauraAug 28, 2025
  If your Branson Tractor's motor starts but the engine doesn't, check if the fuel tank is empty and fill it up, draining the air. Also, check if the fuel is mixed with air, and drain the air from the fuel. If the engine runs only when the reducer lever is pulled, charge the battery. Finally, ensure the fuel cock is set to “O” and not “C”.
J
John NguyenAug 29, 2025
What causes irregular engine revolution in my Branson 00 Series?
- J
  johnstoncynthiaAug 29, 2025
  Irregular engine revolution in your Branson Tractor can be caused by air mixed in the fuel system. To resolve this, drain the water and replace the fuel. Alternatively, the injection nozzle may be clogged, requiring repair or replacement, or the fuel filter might be clogged, needing washing or replacement.
J
Joseph JacksonAug 31, 2025
What to do if my Branson Tractor work unit cannot be lifted?
- M
  Martin BoyerAug 31, 2025
  If the work unit on your Branson Tractor cannot be lifted, verify that the hydraulic stop/slow return valve is set to “Open.” Refill the transmission fluid if the level is low. Check for air in the intake pipe system; tighten the filter case or connection parts, and replace any damaged pipes or O-rings. Clean or replace the oil filter if it's clogged. If problems persist, the hydraulic pump may be out of order, or the control valve may be dusty or have a damaged O-ring, requiring you to contact the dealer for repair.
S
Sarah MillerSep 2, 2025
What to do if my Branson Tractor work unit cannot be lowered?
- J
  John RamosSep 2, 2025
  If the work unit on your Branson Tractor cannot be lowered, first check if the cylinder is damaged and contact the dealer for repair if it is. Ensure the hydraulic stop/slow return valve is set to “Open.” If the control valve is dusty or stuck, consult the dealer for repair. Also, make sure the position control lever is not on the shallowest position; if it is, move it to the releasing direction.
K
Kenneth RamirezSep 3, 2025
Why is the coolant warning lamp on during operation of my Branson Tractor?
- W
  William SmithSep 3, 2025
  The coolant warning lamp during operation of your Branson Tractor is likely due to a low coolant level in the reservoir. Refill the coolant to resolve this issue.
B
billyaguilarSep 5, 2025
What to do if my Branson Tractor battery warning lamp is on during operation?
- S
  Sean HowardSep 5, 2025
  If the battery warning lamp is on during operation of your Branson Tractor, it could indicate that the regulator (current limit) is out of order, in which case you should contact the dealer for repair. Alternatively, the fan belt may be slack or damaged, requiring adjustment or replacement.

Branson 00 Series Specifications

General

Manufacturer	Branson
Series	00 Series
Category	Tractor
Hydraulic System	Open Center
Fuel Tank Capacity	9.5 gallons

Summary

General Precautions and Safety

About Warranty

Warranty Information and Dealer Contact

Information on warranty paperwork and what to provide when contacting a dealer for service.

Overview of the Tractor

Tractor Functions

Switches and Levers

Identification and function of primary switches and levers on the tractor.

Tractor Pedals Operation

Description of clutch, brake, accelerator, and HST pedals.

Lever Operation

Explanation of main gear, range shift, PTO, and park brake levers.

Other Controls

Details on differential lock, seat, and seat belt functions.

Operation and Work

Pre-Operation Checks and Safety

Essential safety checks and procedures to perform before starting tractor operation.

Engine Start-Up and Shutdown Procedures

Step-by-step guide for safely starting and stopping the tractor engine.

Safe Driving Practices

Precautions for driving on roads, slopes, and general operation.

Implement Handling and Connection

Guidance on differential lock, loading, and 3-point hitch usage.

Periodic Maintenance and Adjustment

Periodic Maintenance Schedule

Table detailing maintenance tasks and intervals based on running hours.

Fluid, Filter, and Lubrication Guide

Information on oils, grease, coolant, fuel, and filter replacement.

Component Checks and Adjustments

Covers air cleaner, battery, steering, brakes, and other key components.

Troubleshooting

Engine Troubleshooting Guide

Solutions for common engine starting and running problems.

Clutch and Brake Troubleshooting

Diagnosing and resolving issues with the clutch and brake systems.

Hydraulic System Troubleshooting

Solutions for problems related to the tractor's hydraulic system.

Electrical System Troubleshooting

Diagnosing and fixing issues with lights, horn, and other electrical components.

Specifications

Related product manuals

Preview: Branson K62

Preview: Branson 3015r

Preview: Branson 6640C

Preview: Branson 20R series

Branson 20R series