• • •
72
3. 3PT POSITION CONTROL LEVER
It is used to keep the implement constantly at a certain
position. When the lift lamp is on, the implement cannot
be lowered with position control lever. A stopper is used
to x the position control lever in the “UP” position while
driving on a road.
•When lowering the implement, set the position control
lever, and the implement will go down to the set position.
FUNCTIONS
Conrm that no one or a foot is under the
implement before operating the system.
WARNING
[Otherwise]
There is a danger of injury
4. PTO LEVER
Two levels PTO speed.
(1st Rear 540rpm : 2nd Rear 960rpm - Mid 2500 rpm)
When shifting level, press clutch pedal deeply.
PTO 1 540 RPM
PTO 2 960 RPM (Mid PTO 2500 RPM)
Observe the PTO speed designated on the
implement. Otherwise, the implement may
be damaged and cause an accident.
CAUTION
00 OPERATORS MANUAL (040512).indd 72 4/12/2012 10:19:50 AM
To Next Page
Loading...
