Branson Sonifier 250 - Page 6

ii 100-413-016 Rev. C
Chapter 5: Technical Specifications
5.1 Specifications - - - - - - - - - - - - - - - - - - - - - - - 5-2
5.1.1 Electrical Specifications - - - - - - - - - - - - - - - - 5-2
5.1.2 Mechanical Specifications - - - - - - - - - - - - - - - 5-3
5.1.3 Dimensions - - - - - - - - - - - - - - - - - - - - - 5-4
Chapter 6: Operation
6.1 General Operation - - - - - - - - - - - - - - - - - - - - - 6-2
6.1.1 Timed Operation - - - - - - - - - - - - - - - - - - - 6-2
6.1.2 Continuous Operation - - - - - - - - - - - - - - - - - 6-2
6.1.3 Pulsed Operation - - - - - - - - - - - - - - - - - - - 6-2
6.2 Operating Considerations - - - - - - - - - - - - - - - - - 6-3
6.2.1 Limiting Temperature Rise - - - - - - - - - - - - - - - 6-3
6.2.2 Vessel Capacity and Speed of Temperature Rise - - - - - 6-5
6.2.3 Minimizing Undesirable Factors - - - - - - - - - - - - - 6-5
6.2.4 Sterilizing and Preventing Cross-Contamination - - - - - 6-6
6.2.5 Disrupting Tissues and Solids - - - - - - - - - - - - - 6-6
6.2.6 Using Glass Powders with Solution - - - - - - - - - - - 6-7
6.3 Horn and Micro Tip Amplitudes- - - - - - - - - - - - - - - 6-8
Chapter 7: Maintenance
7.1 General Information - - - - - - - - - - - - - - - - - - - - 7-2
7.2 Maintenance and Troubleshooting - - - - - - - - - - - - - 7-2
7.2.1 Tip Erosion - - - - - - - - - - - - - - - - - - - - - - 7-2
7.2.2 Power Output Loss - - - - - - - - - - - - - - - - - - 7-2
7.3 Preventive Maintenance - - - - - - - - - - - - - - - - - - 7-3
7.4 Reconditioning the Stack Interface - - - - - - - - - - - - - 7-3
7.4.1 Refacing the Mating Surfaces - - - - - - - - - - - - - 7-4
7.4.2 Stud Replacement - - - - - - - - - - - - - - - - - - 7-6
7.4.3 Horn Tip Cleaning- - - - - - - - - - - - - - - - - - - 7-7
7.4.4 System Trouble Analysis Chart- - - - - - - - - - - - - 7-7