Step 1 Switch the bath o by removing the plug from the socket.
Step 2 Empty all of the water from the bath.
Step 3 Remove the filter from the housing and leave the lid o.
Step 4 Clean the inside of the filter and the bath with a disinfectant spray.
Use a vet vac if necessary to remove all water.
Step 5 Leave the insulated cover slightly o to allow air flow to the inside of the bath.
Step 6 Upon returning, follow the ‘getting set up’ instructions.
If you are likely to be leaving
the bath for less than a month
and would like to conserve
energy, simply set the bath to
10 degrees and leave it. This will
ensure minimum energy is used
but the filtration still continues to
be eective.
Going on holiday
If you are going away for more than a month we recommend the following action is taken:
25Ice Bath Quickstart Guide24 Ice Bath Quickstart Guide
To Next Page
Loading...