BRASS MONKEY Ice Bath - Changing the UV Bulb; UV Bulb Replacement Guide

To Next Page

To Previous Page

Changing the UV bulb

Step one

Put the bath into maintenance

mode by pressing and holding

“Ice Boost” for 3 seconds

(everything will switch o).

Step two

Locate the UV bulb chamber.

Step three

Push down the chamber cap and

turn anti-clockwise until it releases.

Put to one side.

Step four

Remove the bulb.

Step ve

Insert the new UV bulb, gently

lowering the bulb halfway in. When it

is halfway you can ax the chamber

cap onto the uv bulb with the 4 pins

on the bulb located into the holes on

the chamber cap.

Step six

Now secure the chamber cap by

locating it back into the unit - push

down and turn slightly until it locks

into position.

Step seven

Exit maintenance mode by pressing

and holding “Ice Boost” for 3 seconds

The bath will now begin running again.

The bath must either be in maintenance mode or switched o to perform

this function.

3 sec

17Ice Bath Quickstart Guide16 Ice Bath Quickstart Guide 17