GETTING SET UP
Install the lter
Step one
Locate the lid of the filter housing
and lift the tab as shown above.
Step two
Now you can unscrew the collar
and remove.
Step three
Pull firmly on the handle to release
the lid.
Step four
If it is tight release air by slightly
unscrewing the air relief key. Do not
remove it.
Step ve
Pop the white paper filter in so that it
secures into the fitting at the base of
the filter housing.
Step six
Replace the collar by rotating the
outer ring clockwise until the tab
clicks into place. Do not over-tighten.
Leave the bath unplugged whilst setting up
6 Ice Bath Quickstart Guide 7Ice Bath Quickstart Guide
To Next Page
Loading...