GETTING SET UP
Filling the bath
Step one
Fill the bath from a clean tap water
supply to 3cm above the water outlet,
allowing for some water displacement
when you get in.
Step two
When the bath is filled to the
correct level, bleed any air out of the
filter by loosening the air relief key
on the filter until all air has escaped.
Then you can tighten it back up.
Step three
Plug the bath in and switch it on.
The power supply should be
connected to an RCD circuit.
We do not advise using
extension cables.
Step four
Set your desired temperature
from 10°C down to as low as 0°C.
If you would like ice to be created
within the bath set it to 0.6 °C.
PROPRIETARY AND CONFIDENTIAL
THIS DRAWING CONTAINS INFORMATION WHICH IS THE PROPRIETARY
PROPERTY OF BALBOA WATER GROUP. REPRODUCTION IN WHOLE OR IN
PART WITHOUT EXPRESS WRITTEN PERMISSION IS PROHIBITED.
Overlay Graphics Template (VL240, ML240)
Use this to create overlay graphics only. Do not use this template to create a die cutting tool.
06
Important!
Do not bleed the filter whilst the power is on as this can cause air locks
which result in an inecient filter.
Do not remove the air relief key completely or the black washer that seals
the key - this can result in filter malfunction.
9
3cm
The bath can take up to 24 hours to
get down to freezing temperatures.
When it is down to temperature,
toggle up and down by 0.1°C to
achieve your desired level of ice.
9Ice Bath Quickstart Guide8 Ice Bath Quickstart Guide 11
To Next Page
Loading...