Braun Silk-expert Pro 3 PL-3133 - Usage and Treatment; Preparation of the treatment area; Device Operation; Patch Test

23
How to use
Preparing the treatment area
Remove any visible hair on the skin before using the device. You may use your preferred hair removal
method. To keep the treatment window clean and intact, ensure there is no hair remaining on the skin
surface. Clean the treatment area and pat it dry.
To power on the device:
Use the mains cord (8) to connect the base station to an electrical outlet. Press the gentle mode button (4)
to activate the device. The LED power bars (3) will light up once and, a fan starts running. This means the
device is in READY mode. During operation, the device will heat up slightly.
Automatic light adaptation
When both skin tone sensors (2) have skin contact, the device reads your skin tone and selects the
appropriate light intensity which is indicated by white LEDs on the Power bars (3). These confirm that the
device is ready to flash.
light skin tone U high light intensity
dark skin tone U low light intensity
no LEDs
no skin contact U device will not flash
red LED
invalid skin tone U device will not flash
Sensitive mode
Push the sensitive mode button (4) to reduce the light intensity. The sensitive mode indicator lights up
when it is activated. To deactivate it, press the sensitive mode button again.
The power bars flash to confirm a change in the light intensity. When holding the sensitive mode button (4)
longer than 3 seconds, the device is deactivated.
After 10 minutes without use, the device is automatically deactivated.
To re-activate it, press the gentle mode button.
Patch Test
Before your first treatment, we recommend you test your skin for reaction to Braun Silk·expert on a small
area of skin of the body part you plan to treat (about 2 x 3 cm in size; equivalent to the size of two flashes,
side by side).
Perform a patch test as described below in chapter «Treatment methods», section «STAMPING».
Wait 48 hours to examine the test area. If the skin appears normal, begin your first treatment. If a skin
reaction develops, discontinue using the device and consult your physician. Do not treat the patch tested
area for at least one week after the test.
90181003_Eclipse_PL-3133_JP_UI_148x210.indd 2390181003_Eclipse_PL-3133_JP_UI_148x210.indd 23 30.07.21 10:3030.07.21 10:30