11
Swelling and redness around the hair follicle that
does not disappear within two to three days.
Stop using the device and consult your physician
before using it again.
Temporary changes in skin color (lightening or
darkening).
If your skin color changes, stop using the device
and consult your physician.
Increase in hair growth in areas of treatment (more
likely to be seen with subjects of Mediterranean
descent).
If this increase persists over several treatments,
stop using the device and consult your physician.
In case of adverse events please contact your national competent authority and the device manufacturer.
Trouble shooting
The following troubleshooting guide may help you solving initial problems you may experience with this
device.
Problem Solution
Power bars do not light up when treatment window
is placed on the skin.
Make sure the device is connected to an electrical
outlet. Press any button (4 or 5) to activate it.
Ensure both skin tone sensors are in full contact
with the skin. If needed, move the device in a way
that both skin tone sensors get skin contact.
The device doesn’t work on small areas. Use the precision head (12) on small, hard-to-
reach areas.
Make sure both skin tone sensors are in contact
with the skin.
Flashing sequence slows down. Device is in heat-protection mode. To get back to
normal speed, allow device to cool down.
On the power bar, only the first LED illuminates
red.
Invalid skin tone reading. Your skin is either too
light or too dark. The device will not flash.
Centre mode button light is flashing. Device is deactivated. Press any button to
re-activate it.
First LED on power bars flashes red. Head (10, 11, 12) has been taken off. Re-attach it.
The power bars show an unfamiliar pattern of one
red LED shining along with individual white LEDs.
Device error. Device will not operate.
Unplug and reconnect. If error persists, contact a
Braun Service Centre for repair.
All white LEDs flash. End of product lifetime. Maximum number of
flashes (400,000) has been reached.
The device is broken, cracked or appears
defective.
Do not use if the handle, the base station or the
mains cord is damaged. If you are in any doubt
about the safety or suspect it is damaged in any
way, you must not use it.
Disposal
The product contains recyclable electronic waste. To protect the environment, do not dispose of
it in the household waste, but take it to appropriate local collection points.
90485907_Vic3_UI_PL7_UK.indd 1190485907_Vic3_UI_PL7_UK.indd 11 21.12.22 08:2521.12.22 08:25
To Next Page
Loading...
