SERIES 54 PROXIMITY SENSORS
Installation, Operation, and Maintenance Manual
10 of 28© 2022 BRAY INTERNATIONAL, INC. ALL RIGHTS RESERVED. BRAY.COM The Information
contained herein shall not be copied, transferred, conveyed, or displayed in any manner that would
violate its proprietary nature without the express written permission of Bray International, Inc.
NOTICE
Cable glands used must be certified in accordance with the
application The temperature range of cable glands must
be selected according to application The degree of ingress
protection must not be reduced by cable glands
The cable gland connections must be properly sealed to maintain
the Ingress Protection rating of the S sensor Use a seal that
meet the requirements of the application
If the sensor is mounted on a vertical pipe it is recommended
that the sensor be positioned with the cable glands on the
bottom to prevent condensation from entering the sensor
through its conduits
In all cases the conduit should be positioned to prevent drainage
into the sensor
Ensure adequate drainage of wiring conduit to prevent water
contamination inside sensor
To Next Page
Loading...
Need help?
General