SERIES 54 PROXIMITY SENSORS
Installation, Operation, and Maintenance Manual
7 of 28© 2022 BRAY INTERNATIONAL, INC. ALL RIGHTS RESERVED. BRAY.COM The Information
contained herein shall not be copied, transferred, conveyed, or displayed in any manner that would
violate its proprietary nature without the express written permission of Bray International, Inc.
PRE-INSTALLED STORAGE
Bray Series Proximity Sensors are not weatherproof until
the unit is properly installed or all conduits and applicable port
connections are sealed o and prepared for storage The units
may be shipped with temporary covers to prevent foreign matter
from entering through the conduit openings however the user is
responsible for replacing with the proper sealing plugs to support
its NEMAIP ratings
To prevent condensation from forming inside the unit maintain
a near constant external temperature and store indoors in a well
ventilated clean dry room The temperature shall be between
F (C) and F (C) with a relative humidity less than
Store units away from vibration and direct sunlight exposure
and place units on a shelf or wooden pallet in order to protect
against dampness Keep units covered to protect against dust
and dirt if storing for long term placing the unit inside a plastic
sealed bag may be preferred
Bray cannot accept responsibility for deterioration caused on-site
once the cover is removed or due to improper storage
To Next Page
Loading...
Need help?
General