Bray DC24 Series - Page 5

5
DC(M)24-(44/88) Series - Installation, Operation & Maintenance Manual Continued
When using a 3/8-inch shaft: Remove factory-installed
1/2-inch guide. See Figure 3
When using a 5/8-inch shaft:
1. Remove factory-installed 1/2-inch guide. See Figure 3.
2. Mount actuator to shaft per Figure 6.
1. A 3/8-inch shaft adapter is provided in actuator
package.
2. Hold the shaft insert so that the raised tabs are
inserted last when placing the insert into the
back of the actuator.
3. Proceed to Figure 6
Figure 3. Removing 1/2-inch Ø Shaft
Guide for 3/8-in or 5/8-in Shaft.
Figure 4. 3/8-inch Ø Shaft, See Figure 1 Item f.
Figure 5. 5/8-inch Ø Shaft.
Figure 6. Mounting Actuator to Damper Shaft.
Figure 7. Installing the Position Indicator (b).