i
TRO_UBLE_SHOOTING. ...........
Symptom Possible Solutions
The bread rose Make sure not to add too much yeast, water or flour. Too
too high much of any of these may cause the loaf to rise more than
it should. " .
The bread didn't
rise enough
Make Sure not to add too little yeast, water or sweetener.
Make sure to add ingredients in the propel order: liquids,
dry ingredients, yeast. Make sure yeast doesn't get wet
-unti-l=the-Breadman®-mixes_the-ingredients-togeth-er:
Note: Typically, bread made with whole grain flours
will not rise as high as bread made ,with refined flours.
The dough looks
like batter, or the
dough ball is still
sticky, not smooth
and round
During the Kneading process, add 1 tablespoon of flour at a
time, letting it mix in well. For most breads, your dough ball
should become round, smooth, not sticky to the touch, and
should bounce back when you press it with your finger.
.... The dough ball is
lumpy or too dry .
During the Kneading process, add 1 tablespoon of water at a
time, letting it mix in well.
E:01 displays
when you press
Start button
The Breadman ®is too hot (over 100°F/38°C) to begin
preparing another loaf. Remove the Bread Pan with your
in_edients, and wait until the Breadman ®cools down about
20 minutes -- before'preparing a new loaf.
E:02 displays
when you press
Start button
H:00 displays
after baking
L:00 displays
after baking
The Breadman ®is too cold. Unplug the machine and allow it
to heat up to room temperature, then try again. '
This means the temperature of the dough was too high during
the Kneading or Rising process. Locate the Breadman ® in a
cooler place.
This means the temperature of the dough was too low during
kneading or rising. Locate the Breadman ®in a warmer place.
20
To Next Page
Loading...
