Brent 1082/882 — Operation
3-3
Preparing Tractor
Before operating cart, read the tractor Operator’s Manual and gain an understanding of its
safe methods of operation.
Check the tractor brakes and transport lights. Make sure they are in proper working order.
Check the tractor hydraulic oil reservoir and add oil if needed.
Verify that the tractor is adequately ballasted for drawbar operation at the anticipated draft
load. See tractor manual for ballasting instructions.
If possible, adjust the tractor drawbar vertically so the topside of the drawbar is approximately
17-22 inches from the ground. Ensure that the drawbar is locked in the center position.
On tractors equipped with a 3-point hitch, raise and secure the linkage to prevent interfer-
ence with the cart tongue, hydraulic hoses and the hydraulic drive option during turning. It
may be necessary to remove tractor 3-point quick attach to avoid damage during turning.
Preparing Cart
Perform the service checks as outlined below. Repair or replace any damaged or worn parts
before operating.
Hardware
Check for loose bolts and nuts, and tighten as needed. Check again after the fi rst half-day
of operation.
Pivot Pins
Check that all pins are in place and in good condition. Replace any worn, damaged or
missing pins.
Hitch
Check hitch wear plates for damage and wear. Be aware of the size of hitch adapter bushing
that is being used. Select correct size for the hitch pin/draw bar you are using.
Auger
Inspect auger for damage and wear.
• Remove transport retainer located on auger
rest, before folding out upper auger.
(July 2015)
To Next Page
Loading...
